咸宁附近想过夜电话联系

Ceramic fiber gasket Many industrial kilns rely on the prevention of leakage parts. Ceramic fiber gasket can be very good to the flange, the position of each pipe interface and the gap between furnace door and valve to avoid the loss of a lot of heat, reduce the heat flow of the equipment and increase the efficiency. So in addition to the ceramic fiber gasket is well integrated into the equipment, what other problems need to be paid attention to, which can help the efficient use of the equipment?

 What should be considered in addition to using ceramic fiber gasket to prevent leakage?

For pipe parts: for the parts with expansion joints, ceramic fiber gasket and other devices must be required to ensure that the joints can be well sealed after a large number of gaps appear. And also need to set up the corresponding pipe support to ensure that the pipeline is normal and not twisted. Reasonable planning of the overall length of the pipeline, to avoid the long pipeline is not conducive to management and a lot of energy loss. Moreover, it is necessary to maintain the pipeline regularly and make corresponding records.

For valve parts: the valve should be set in a relatively obvious position, and the corresponding maintenance platform or lifting device should be installed for the valve at a higher position to ensure the convenience of maintenance at any time during use. When closing or opening the valve, excessive torque should not be used to cause damage to the valve, which will reduce the sensitivity of the valve in the long run.

For the core equipment such as furnace, the number of furnace door and pipe hole should be reduced as much as possible. In addition, it is suggested to use the ceramic gasket in the furnace door to perfect the gap. Ensure that the equipment does not dissipate heat and lose heat. When the furnace works normally, the frequency of opening the equipment should be reduced as much as possible, so as to avoid air convection between the outside air and the internal air and take away the heat in the furnace.

In addition to the above mentioned, in fact, when installing the equipment, the ceramic fiber sheet can be installed as far as possible in the leakage position. And for the whole set of furnace and cellar equipment, some other ceramic fiber series products can also be used for external packaging to ensure energy efficiency as far as possible.


September 4, 2020

What are the characteristics of FRP used as raw material in valve fire hood?
What are the advantages of the factory's fast door and what problems should be paid attention to when choosing?

Last

Next

What should be considered in addition to using ceramic fiber gasket to prevent leakage?

Ceramic fiber gasket is a kind of leakage prevention part for many industrial kilns. Through ceramic fiber gasket, the gap between flange, pipe interface, furnace door and valve can be well mended to avoid the loss of large amount of heat, reduce the heat flow of equipment, and increase the benefit. So in addition to the ceramic fiber gasket is well integrated into the equipment, what other problems need to be paid attention to, which can help the efficient use of the equipment?

Add time: